 |
VERANDA SYSTEM |
|
 |
| Type of application: |
| Vertical, horizontal or sloped |
| Installation: |
| Indoors or outdoors |
| Wind resistance: |
| Class 3 |
|
Product marked:
 |
|
Solid and elegant awning designed for outdoor installations, for verandas and other large horizontal or sloped glassed areas; however it may also be used on vertical windows where, for example, the blind is required to open from the ground upwards.
The Veranda blind has a specially designed traction bar to guarantee constant fabric tension in any position.
The Veranda blinds may be installed side by side, double module possible with only one motor. The blind structure is made of heavy duty extruded aluminium profiles, consisting of :
- Box: section 161 x143 mm, with removable cover
Guides: lateral guides 65x65 mm
- Bottom bar with mobile cover 80x55 mm containing a pre-loaded spring. The bottom bar is moving on special side-caps equipped with bearings. It works on the back-pull principle. The tension is made by PES wires in the guides. These wires are connected to plastic pulleys mounted on the rolling tube.
- Roller tube: Ø 78 mm galvanized steel tube, thickness 1.25 mm, with special groove into which the welded strip on the fabric is inserted.
OPTIONAL:
- Remote control (choice of receiver incorporated in the motor or separate), electronic control units for multi-level automation, sun/wind sensors.
- Choice of mounting brackets for the installation on any surface.
ADVANTAGES:
- Covering of large surface areas, up to 18 m² per module.
- Great flexibility, the system may be installed in any position.
- Optimum solar protection may be obtained by positioning the blind at approximately 40 cm from the window pane, hence reducing the greenhouse effect to a minimum.
- Possibilità of operating two modules with a single motor.
- Wind resistance: Class 3
|
|
VERANDA WITH CABLE
|
|
 |
| Type of application: |
| Vertical, horizontal or sloped |
| Installation: |
| Indoors or outdoors |
|
|
- Box: section 161 x143 mm, with removable cover
- Stainless steel wires – 6 mm diam – with lower stainless steel fixing brackets
- Bottom bar with mobile cover 80x55 mm containing a pre-loaded spring. The bottom bar is moving on special side-caps equipped with bearings. It works on the back-pull principle. The tension is made by PES wires in the guides. These wires are connected to plastic pulleys mounted
on the rolling tube
- Cast aluminium side-caps
- Roller tube: Ø 78 mm galvanized steel tube, thickness 1.25 mm, with special groove into which the welded strip on the fabric is inserted
ADVANTAGES:
- It can be used for big surface cover – up to 18 sqm per module
- It allows for a good protection by limiting in this way the green haus effect. It can be supplied with spacing supporting brackets
- Good air circulation
- It is possible to operate two modules with one motor
|
|
 |
Max dimensions per module:
W : 450 mm
H : 500 mm
Max surface area 18 m²
|
|
Fixed structure
Motorised only
|
|
| References for this product family: |
|
|
|
