 |
SYSTEMS FOR FACADES – BPL & DALLAS SYSTEMS |
|
 |
| Type of application: |
| Vertical |
| Installation: |
| Outdoor |
| Wind resistance: |
| Class 3 |
|
Product marked:
 |
|
Two highly technical motorised roller blind systems with stainless steel bar guides, purposely designed for building façades. These elegant systems allow shading of vast glass areas whilst becoming part of the architecture, with the possibility of floor as well as face mounting.
|
|
 |
 |
MCGL250/506/507
Version BPL |
MCGL250/506/507
Version DALLAS |
The aluminium structure is available in anodised silver or powder enamelled RAL colours and consists of: Versione BPL
- Box : mod. CT110 in extruded aluminium Ø116 mm; cast aluminium cheeks, (into which the steel guide bars are inserted) with recess to house the compensating springs. Shaped, upper and lower, cast aluminium mounting brackets: the upper brackets are mounted directly to the cheeks, the steel bar guides are screwed into the lower brackets.
- Stainless steel bar guides, Ø 8 or Ø 10 mm, AISI 316; complete with stainless steel spring to compensate any thermal dilation.
- Bottom rail : mod. FD42, extruded aluminium Ø 42 mm tube, adequately weighted with galvanized steel rods and complete with end plugs in delrin that permit the rail to run smoothly up and down the guide bars.
- Roller tube : Ø 53/57 or Ø 60 mm in extruded aluminium; or Ø 78 mm, 1.25 mm thick, galvanised steel tube with slot for mounting fabric.
- Tubular motor, single phase, 230 V 50 Hz, adjustable limit switch and thermal cut-out with level IP44 protection
Versione DALLAS
- Box mod. CT110, Ø 116mm in extruded aluminium; stainless steel cheeks AISI 316 composed of two flanges that clamp onto the steel bar guides and hence support the whole blind. The box is hence suspended on the bar guides and not fixed to the building.
- Stainless steel bar guides, mod. D10, Ø 10 mm, with elegant fixing brackets for wall or ceiling/floor mounting; both in stainless steel AISI 316/304 (depending upon requirements).
- Bottom rail : mod. FD42, extruded aluminium Ø 42 mm tube, adequately weighted with galvanized steel rods and complete with end plugs in delrin that permit the rail to run smoothly up and down the guide bars.
- Roller tube : Ø 53/57 or Ø 60 in extruded aluminium; or Ø 78 mm, 1.25 mm thick, galvanised steel tube with slot for mounting fabric.
- Tubular motor, single phase, 230 V 50 Hz, adjustable limit switch and thermal cut-out with level IP44 protection
OPTIONAL:
Remote control, electronic control units for multi-level automation, sun/wind sensors
ADVANTAGES:
- Elegant and highly technical roller blinds with excellent wind resistance
- Wide choice of fixtures suitable for any architectural structure
|
|
 |
L 320 x H 400 cm o
L 400 x H 300 cm max
|
|
Box
Only Motorised operation |
|
| References for this product family: |
|
|
|
